Direct Draw Draft Arm Installation; Co₂ Pressure; Kegerator Installation - True TDB-24-48-1-G-1-HC Installation Manual

Cabinet Setup (cont.)

Direct Draw Draft Arm Installation

On direct draws, the drain is located at the front of the cabinet.
To plumb in the drain, connect 3⁄4" (19.05 mm) P.V.C. pipe to the
3⁄4" (19.05 mm) barbed fitting supplied with the unit.
CO₂ Pressure
Mobile tapsters, to retain complete mobility, the CO₂ tank
(up to 5 lb. (2.3 kg) in size) can be placed inside the cooler
(strap holders furnished).

Kegerator Installation

Kit Components
a. Hole Cover*
b. Draft Tower (Double Tower shown)
c. Rubber Gasket
d. O-Ring(s)
e. Draft Tower Hardware (x8)
f. Draft Tower Handle(s)
g. CO₂ Cylinder* (shipped empty, fill before use)
h. Double CO₂ Pressure Regulator*
i. Beer Tappers*
j. 5/16" I.D. x 9/16" O.D. Clear Vinyl Tubing with Clamps
[36" (914.4 mm)]
*TDB-1 kit only
Required Tools
Required tools include (but may not be limited to) the following:
• Phillips Screwdriver
• Adjustable Wrench
• 1/4" Socket Wrench
• Leak Check Solution
WARNING
Take care when handling filled CO₂ tanks.
If unfamiliar with using CO₂ tanks and/or
regulators, seek information from your local
distributor or brewer representative before
proceeding.
Before You Begin (TDB-1 only)
If the application will not use the kegerator system, then, with
the provided hardware, install the hole cover over the draft
tower hole. See fig. 1.
Procedure
1. Position the rubber gasket over the mounting holes in the
cabinet counter top. See fig. 2.
2. Insert the o-rings into the beer line connectors. See fig. 3.
3. Run the beer line through the hole and into the cabinet.
See fig. 4.
4. With the provided hardware, install the draft tower.
See fig. 5.
TEC_TM_114 | REV. C | EN
U N D E R B A R R E F R I G E R A T I O N
– Contents under pressure.
F
B
A
C
D E
Fig. 1. Install the hole cover over the draft tower hole if not using the kegerator system.
Fig. 2. Position the rubber gasket around
the draft tower hole.
Fig. 4. Thread the beer lines into the
cabinet.
03/1/2023
truemfg.com
G
H
I
Fig. 3. Be sure to insert the o-ring in the
beer line connector.
Fig. 5. Secure the draft tower to the
countertop.
Page 11 of 28
J