Elevating Legrest With Length Compensation - Physipro SPIRAL Owner's Manual

ENGLISH

4.20 Elevating legrest with length compensation

The Spiral tilt in space wheelchair can be equipped with 14" to 19" (35,6 to 48,3 cm)
Adjusting the height of the legrest :
1. Install the legrest in the receiver on the chair (See section: 3.8);
2. Unscrew the bolt (A);
3. Move the legrest support rod (B) to the desired height;
4. Tighten the bolt (A);
Adjusting the angle of the legrest :
1. To inscrease the angle, pull the legrest upwards;
2. To reduce the angle, press the settings remote (C) while lifting the weight of the user's
leg, lowering the legrest to the desired angle;
48
Figure : Adjusting the elevating legrests with length compensation
46
46
Spiral
Révision 0
juillet 18