Table of Contents
Advertisement
8)
Press as to select the lens type.
f Select the type of projection lens attached to the projector.
9)
Press the <执行> button.
Note
f For details of operation, refer to the [PROJECTOR SETUP] menu → [LENS] → [LENS TYPE] (x page 166).
Executing the lens calibration
Detect the lens adjustment limit value, and perform the calibration in the adjustment range. Execute the lens
calibration after attaching the projection lens.
Zoom Lens with DC motor, the Fixed-focus Lens
This section describes the operating procedure when the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8,
ET-D75LE10C, ET-D75LE20C, ET-D75LE30C, ET-D75LE40C, etc.) in which the DC motor has not been
replaced with the stepping motor unit is attached, or when the Fixed-focus Lens (Model No.: ET-D3LEW50C,
ET-D75LE50C, ET-D75LE95C, ET-D3LEF70C, etc.) without the zoom function is attached.
1)
Press the <菜单> button.
f The [MAIN MENU] screen is displayed.
2)
Press as to select [PROJECTOR SETUP].
3)
Press the <执行> button.
f The [PROJECTOR SETUP] screen is displayed.
4)
Press as to select [LENS].
5)
Press the <执行> button.
f The [LENS] screen is displayed.
6)
Press as to select [LENS CALIBRATION].
7)
Press the <执行> button.
f The confirmation screen is displayed.
8)
Press qw to select [OK], and press the <执行> button.
f The lens calibration is started.
f After completing the calibration in the adjustment range, the projection lens will move to the home position.
Note
f [LENS CALIBRATION] cannot be executed when the [PROJECTOR SETUP] menu → [LENS] → [LENS TYPE] is set to [NOT SELECTED].
f For details of operation, refer to the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION] (x page 177).
f The origin position of the lens mounter and the home position of the projection lens are automatically updated when the lens shift calibration
is performed. The home position is an origin position of the lens shift (vertical position and horizontal position of the lens) based on the
calibration result. It does not match with the optical image center position.
f The home position varies depending on the projection lens type. For details, refer to "Lens shift range" (x page 86).
Zoom Lens with the stepping motor
This section describes the operating procedure when the standard DC motor unit installed in the Zoom Lens
(Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10C, ET-D75LE20C, ET-D75LE30C, ET-D75LE40C, etc.)
is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10), or when
the Zoom Lens with the stepping motor (Model No.: ET-D3LEW60C, ET-D3LEW10C, ET-D3LES20C, etc.) is
attached.
1)
Press the <菜单> button.
f The [MAIN MENU] screen is displayed.
2)
Press as to select [PROJECTOR SETUP].
3)
Press the <执行> button.
f The [PROJECTOR SETUP] screen is displayed.
4)
Press as to select [LENS].
Chapter 3 Basic Operations — Projecting
ENGLISH - 83
Advertisement
Table of Contents
