Table of Contents
Advertisement
f When [MECHANICAL SHUTTER] is set to [ENABLE], it will take approximately 0.5 seconds from when the shutter function is enabled
(shutter: closed) to the shutter function is disabled (shutter: opened).
f Even if [MECHANICAL SHUTTER] is set to [DISABLE], the projector will go into the standby status with the mechanical shutter closed when
[SHUT-OFF] is set to [CLOSE] and the power is turned off.
f The light source may turn on darker to warm up when the shutter function is used when the operating environment temperature is around
0 °C (32 °F) when [MECHANICAL SHUTTER] is set to [DISABLE].
Setting [FADE-IN] or [FADE-OUT]
Set the image fade-in and fade-out when the shutter function operates.
1)
Press as to select [SHUTTER SETTING].
2)
Press the <执行> button.
f The [SHUTTER SETTING] screen is displayed.
3)
Press as to select [FADE-IN] or [FADE-OUT].
4)
Press qw to switch the item.
[FADE-IN]
[FADE-OUT]
Note
f Press the <快门> button on the remote control or the control panel during fade-in or fade-out to cancel the fade operation.
Setting [STARTUP]
Automatically enable/disable the shutter function (shutter: closed/opened) when the power is turned on.
1)
Press as to select [SHUTTER SETTING].
2)
Press the <执行> button.
f The [SHUTTER SETTING] screen is displayed.
3)
Press as to select [STARTUP].
4)
Press qw to switch the item.
[OPEN]
[CLOSE]
Setting [SHUT-OFF]
Sets to automatically opens/closes the mechanical shutter when the power is turned off.
1)
Press as to select [SHUTTER SETTING].
2)
Press the <执行> button.
f The [SHUTTER SETTING] screen is displayed.
3)
Press as to select [SHUT-OFF].
4)
Press qw to switch the item.
[CLOSE]
[KEEP CURRENT STATE]
[OPEN]
Chapter 4 Settings — [DISPLAY OPTION] menu
Item
[OFF]
[0.5s] - [10.0s]
The projector goes into projection mode with the shutter function disabled (shutter: opened) when the
power is turned on.
The projector goes into projection mode with the shutter function enabled (shutter: closed) when the
power is turned on.
The projector goes into standby mode with the mechanical shutter closed when the projector is
switched off.
The projector goes into standby mode with the condition of the mechanical shutter maintained when
the projector is switched off.
The projector goes into standby mode with the mechanical shutter opened when the projector is
switched off.
Adjustment
Does not set fade-in or fade-out.
Sets the fade-in or fade-out time.
Select an item from [0.5s] - [4.0s], [5.0s], [7.0s], or [10.0s]. [0.5s] -
[4.0s] can be selected in increments of 0.5.
ENGLISH - 161
Advertisement
Table of Contents
