Account Call Settings - Grandstream Networks GHP6 Series Administration Manual

Symmetric RTP
RTP Timeout (s)

Account Call Settings

Key as Send
No Key Entry Timeout
Send Anonymous
Anonymous Call Rejection
Enable Call Waiting
RFC2543 Hold
Ring Timeout
Auto Answer
Auto Answer Numbers
Intercom
Play warning tone for Auto-
Answer Intercom
Custom Alert-Info for Auto
Answer
Allow Auto Answer by Call-
Info/Alert-Info
Allow Barging by Call-
Info/Alert-Info
● No: No data will be sent
● RTP Version 1: The wrong version infor "1" will be carried when sending RTP data
packets.
Configures whether Symmetric RTP is used or not. Symmetric RTP means that the UA uses
the same socket/port for sending and receiving the RTP stream. The default setting is "No".
Configures the RTP timeout of the phone. If the phone does not receive the RTP packet
within the specified RTP time, the call will be automatically disconnected. The default range
is 0 and 6-600. If set to 0, the phone will not hang up the call automatically.
General
Pressing the selected key will immediately dial out.
Configures the timeout (in seconds) for no key entry.
If no key has been pressed after the timeout, the collected digits will be sent out.
If set to "Yes", the "From" header in outgoing INVITE messages will be set to anonymous.
If set to "Yes", anonymous calls will be rejected.
Enables the call waiting feature. If set to "No", new incoming calls will be rejected after the
call is established.
If set to "Yes", c=0.0.0.0 will be used in INVITE SDP for hold.
Configures the timeoput (in seconds) for the phone to ring when an incoming call is not
answered. Valid range is 30 to 3600.
Auto Answer
If set to "Yes", the phone will automatically turn on the speaker phone to answer incoming
calls after a short reminding beep. Default setting is "No".
Allows the user to configure specific numbers to auto answer. If not set, all numbers will be
auto answered If auto answer is enabled. Up to 10 numbers can be configured.
If enabled, phone will play warning tone when auto answering intercom.
Used exclusively to match the contents of the Alert-Info header for auto answer. The
default auto answer headers will not be matched if this is defined.
If set to "Yes", the phone will automatically turn on the speaker phone to answer incoming
calls after a short reminding beep, based on the SIP Call-Info/Alert-Info header sent from
the server/proxy.
Default is "Yes".
When enabled, the phone will automatically put the current call on hold and answer the
incoming call based on the SIP Call-Info/Alert-Info header sent from the server/proxy.
However, if the current call was answered based on the SIP Call-Info/Alert-Info header, then