Call Settings - Grandstream Networks GHP6 Series Administration Manual

Enable Outbound
Notification

Call Settings

Preferred Default Account
Mute Key Functions While Idle
Do Not Escape '#' as %23 in SIP URI
User-Agent Prefix
Enable Direct IP Call
Onhook Dial Barging
Off-hook Auto Dial
Off-hook Auto Dial Delay
Off-hook/On-hook Timeout (s)
Allow Incoming Call before Ringing
Enable Call Waiting
Enable Call Waiting Tone
Auto Answer Delay
Enable Auto Unmute
Enable Busy Tone on Remote
Disconnect
Configures whether to enable outbound notifications such as Action URL.
General
Select the preferred default account for on-hook or off-hook dialing. when the
selected account is unavailable, system will use the first available account to dial
out.
If set to 'Idle Mute", clicking the MUTE key while idle will cause the phone to be
muted automatically when answering incoming calls.
Replaces # by %23 for some special situations.
Configures the prefix in the User-Agent header
Outgoing
Enables Direct IP Call feature.
When the option is set to "Disabled", onhook dialing won't be interrupted by an
incoming call.
Configures the digits to be dialed via the first account when the phone is off-hook.
Configures the timeout (in seconds) for off-hook auo dial. Valid range is 0-10. If set
to 0, it will be dialed out immediately. Otherwise, it will be dialed out after the
configured timeout.
If configured, when the phone is in the off-hook or on-hook, dialing state, it will go
ilde after the timeout (in seconds). Valid range is 10 to 60.
Incoming
This allows incoming calls after dialed but before ringing. This can be used under
custom user configuration based on need.
Enables the call waiting feature. If set to "No", new incoming calls will be rejected
after the call is established.
Enables Call Waiting alert tone when another incmong call is received while a call is
in progress.
Configures the delay for automatically answering the incoming call. Valid range is 0
to 10 (seconds).
In Call
If the option is enabled, automatically unmute phone when a user unholds the call or
establishes a new call.
Playing busy tone when call is disconnected remotely.