Grandstream Networks GHP6 Series Administration Manual page 26

Web/SSH Access
SSH is often used to "log in" and perform operations on remote computers but it may also be used for transferring data.
Parameter
Enable SSH
SSH Public Key
HTTP Web Port
HTTPS Web Port
Web Access Mode
Web Access Control
Web Session Timeout
Validate Server
Certificates
Web/Restrict mode
Lockout Duration
Web Access Attempt
Limit
User Info Management
Parameter
Test Password Strength
Admin Password
Current Password
New Password
Confirm Password
IVR
Keypad Password
If set to "Yes", the phone will allow any SSH access to the phone.
If enabled, the phone will use public key authentication as an alternative option to password
authentication.
Configures the HTTP port under the HTTP web access mode.
Configures the HTTPS port under the HTTPS web access mode.
Sets the protocol for the web interface.
Restrict web access by using Whitelist or Blacklist on the incoming IP addresses. If set to "None",
the web access is unrestricted.
Configures the timer to log out of the web session when idle. Default is 10 minutes. Range is 2-60
minutes.
Configures whether to validate the server certificate when downloading the firmware/config file. If
set to "Yes", the phone will download the firmware /config file only after the server is validated.
Specifies the time in minutes that the web login interface will be locked out to the user after five
login failures. This lockout time is used for web login. The range is 0-60 minutes.
Configures the number of failed web access attempts allowed before lockout. Default is 5. Range is
1-10.
Checks password strength to ensure better security
The current admin password is required to set a new admin password.
Set new password for web GUI access as Admin. This field is case sensitive.
Enter the new Admin password again to confirm.
Configure the keypad password used in the IVR.
Description
SSH Access
Web Access
Description