Grandstream Networks GHP6 Series Administration Manual page 6

Mark two dots horizontally with a 100 mm distance in between where to wall mount the GHP610/W & GHP611/W.
Using a drill, make a hole on each marked dot. Put a plastic expansion bolt and screw (not provided) on each hole. Leave
enough space to mount the GHP610/W & GHP611/W.
Mount the GHP610/W & GHP611/W on the screws using the Wall Mount Slots.
GHP62X/W
1. On the wall where the GHP62X/W will be mounted, mark two dots with 100 mm distance in-between vertically.
2. Using a drill, make a hole on each marked dot. Put a plastic expansion bolt and screw (not provided) into each hole. Leave
enough space on the screws to mount the GHP62X.
3. Attach the wall mount spacers to the slot for the wall mount spacer on the back of the phones.
4. Mount the GHP62X on the screws using its "Wall Mount Slots".
Connecting the GHP6XX/W
To set up the phone, follow the steps below:
1. Connect the phone cord with the handset (RJ-11 port in GHP61X/W, RJ-9 port in GHP62X/W) and the base.
2. Connect the LAN port of the phone to the RJ-45 socket of a hub/switch on a router ( LAN side of the router) using the
Ethernet cable. This step can be skipped if using GHP6XXW with Wi-Fi.
3. Powering the phone:
For GHP6XXW: Connect the 12V DC output plug into the power jack if the phone; plug the power adapter into the
electrical outlet.
For GHP6XX: A PoE switch must be used in step 2.
Note
For easy deployment, the GHP6xxW is out-of-the-box pre-configured to connect to default SSID named wp_master with a
password (WPA/WPA2 PSK) equal to wp!987@dmin, users can adapt these settings from the web UI as well to make it easier
for deployment on a customer's site.
Phone Configuration Via Web Browser
1. Ensure your phone is powered up and connected to the internet.
GHP61X Wall Mount
GHP61X Wall Mount