Using Ethernet Interface To Setup Ethernet Interface - AMT Datasouth Fastmark M7XPd User Manual

Using Ethernet interface to setup Ethernet interface

1.
Connect the computer and the printer to the LAN.
2.
Turn on the printer power.
3.
Start the Diagnostic Utility by double clicking on the
4.
Select "Ethernet" as the interface then click on the "Setup" button to
setup the IP address, subnet mask and gateway for the on board
Ethernet.
5.
Click the "Discover Device" button to explore the printers that exist on
the network.
6.
Select the printer in the left side of listed printers, the correspondent IP
address will be shown in the right side "IP address/Printer Name" field.
7.
Click "Change IP Address" to configure the IP address obtained by
DHCP or static.
The default IP address is obtained by
DHCP. To change the setting to static
IP address, click "Static IP" radio
button, then enter the IP address,
subnet mask and gateway. Click "Set
IP" button to save new IP address
values.
Users can also change the "Printer
Name" to another model name in this
field. Click "Set Printer Name" to save
new name.
- 53 -
icon.