Printer Function; Setting Ethernet By Diagnostic Utility - AMT Datasouth Fastmark M7XPd User Manual

Printer Function

1.
Select the PC interface connected to the bar code printer.
2.
Click the "Function" button for settings.
3.
The detail functions in the Printer Function Group are listed as below.

Setting Ethernet by Diagnostic Utility

The Diagnostic Utility is enclosed in the CD disk \Diagnostic Utilities directory. Users can
use the Diagnostic Tool to setup the Ethernet by RS-232, USB and Ethernet interfaces.
The following contents will instruct users how to configure the Ethernet by these three
interfaces.
(Calibrate sensor, Ethernet setup, RTC setup...)
Function
Calibrate Sensor
Ethernet Setup
RTC Setup
Factory Default
Reset Printer
Print Test Page
Configuration Page
Dump Text
Ignore AUTO.BAS
Exit Line Mode
Password Setup
For more information about the Diagnostic Tool,
please refer to the diagnostic utility quick start guide
in the CD disk \ Diagnostic Utilities directory
- 50 -
Description
Calibrate the sensor specified in the Printer
Setup group media sensor field
Setup the IP address, subnet mask, gateway for
the on board Ethernet
Synchronize printer Real Time Clock with PC
Initialize the printer and restore the settings to
factory default.
Reboot printer
Print a test page
Print printer configuration
To activate the printer dump mode.
Ignore the downloaded AUTO.BAS program
Exit line mode.
Set the password to protect the settings
.