Programming The Receiver For The Remote; Operational Notes - Carefree PARAMOUNT Installation Manual

Carefree of Colorado
I R
NSTALLING THE
1. Determine the location of the RF receiver:
1.1 Do not mount the unit near heat producing elements
such as LP
components.
1.2 For best reception, do not mount the unit near or on
a metal surface.
1.3 Mount the unit with the antenna pointing up.
1.4 The included cable is approximately 60 inches long.
Mount the unit close enough to the splitter or control
box so that the cord can be connected without
stressing the connections.
1.5 Allow adequate room below the box to access the connector jack, programming button and
indicator light.
2. Position the control box and secure using two (2) #6 x 1/2" screws.
NOTE: If the box is mounted on a surface that is less that 1/2" thick, the screws will protrude
through the opposite side of the surface.
3. Connect the cable to the receiver.
4. Route the cable to the control box and connect to any open "EYE" port.

Programming the Receiver for the Remote

1. Power to the control box must be on.
2. Press and release the "Press to Learn Transmitter" button on
the bottom of the receiver box. The receiver is in program
mode when the red light comes on.
3. Press and release
recommended to use the
after the receiver learns the remote signal.
W
HEN THE RECEIVER LEARNS THE TRANSMITTER SIGNAL
PERFORM THE OPERATION OF THE BUTTON PRESSED
P "E "
RESSING AN XTEND
CAUSE THE AWNING TO EXTEND WHEN THE RECEIVER LEARNS THE SIGNAL
U
SE CAUTION TO AVOID UNEXPECTED MOVEMENT BY THE AWNING
4. Repeat steps 2 and 3 for each additional remote.

OPERATIONAL NOTES:

•
Transmitter and receiver operate on a frequency of 433MHz.
•
The receiver exits the program mode after ten seconds.
•
If the light does not come on in step 2, check the continuity of the cord between the boxes and repair
or replace as required. Pin 1 of the 1
does not come on, the memory is full and must be cleared.
•
If the light does not go out in step 3, the receiver already knows the transmitter's signal or the
battery in the remote needs to be replaced.
•
To clear the memory:
indicator light should be OFF for the full 5 seconds then come on.
•
The system may be programmed for up to 5 remotes. Additional remotes may be ordered
separately.
052548-001r1
Installation Manual
R
EMOTE ECEIVER
appliances or engine
button on the remote.
ANY
button. The red light will go out
STOP
CAUTION
BUTTON DURING THE LEARNING PHASE WILL
st
connector goes to pin 1 of the 2
the transmitter learn button. While holding the button, the
PRESS AND HOLD
(A C
LL ONFIGURATIONS
exhaust
It is
,
THE SYSTEM WILL
. E :
XAMPLE
.
.
Figure 6. Programming the Receiver.
P
ARAMOUNT
)
#6 x 1/2
Screw (2)
3 7/8"
Figure 5. RF Receiver.
UP
Indicator Program
Light Button
RTA022
nd
connector etc. If the light still
Table of Contents
4 3/16"
UP
1"
RTA034
8