Table of Contents
Advertisement
P
ROGRAMMING THE
When adding or replacing a remote control, it is necessary to program the
transmitter and receiver.
1.
Power to the control box must be on.
2.
Locate the receiver box.
3.
Press and release the "Press to Learn
Transmitter" button on the bottom of the
receiver.
The receiver is in program mode
when the red light comes on.
4.
For Single Awning Key FOBS: Press and
release the
STOP
red light will go out after the receiver learns
the remote signal.
NOTE: Pressing the stop button will cause
the blue up arrow button to default as the
open (extend) function.
If a function button is pressed to train the receiver, it will be programmed as
the open (extend) button.
program the bottom button for extend and the top button as retract.
5.
For Multiple Awning Remotes: Press and release the
remote. It is recommended to use the
after the receiver learns the remote signal.
CAUTION
will perform the operation of the button pressed.
"Extend" button during the learning phase will cause the awning to extend when
the receiver learns the signal. Use caution to avoid unexpected movement by
the awning.
6.
Repeat for each additional remote.
OPERATIONAL NOTES:
The transmitter and receiver operate on a frequency of 433MHz.
The receiver exits the program mode after ten seconds.
If the light does not come on in step 2, the memory is full and must be cleared. If
the light still does not come on, check the continuity of the cord between the boxes
and repair or replace as required. Pin 1 of the 1
connector etc.
If the light does not go out above, the receiver knows the transmitter signal
or the battery in the Remote needs to be replaced.
To clear the memory:
holding the button, the indicator light should be OFF for the full 5 seconds
then come on.
The receiver may be programmed for up to 5 remotes. Additional remotes
may be ordered separately.
RF R
ECEIVER FOR A
button on the remote. The
Example:
When the receiver learns the transmitter signal, the system
PRESS AND HOLD
R
EMOTE
Indicator
Light
Pressing the bottom button will
button. The red light will go out
STOP
Example:
st
connector goes to pin 1 of the 2
the receiver learn button.
APEX
UP
Program
Button
WS018
button on the
ANY
Pressing an
nd
While
9
Advertisement
Table of Contents
