Programming The Rf Receiver For A Remote - Carefree Mirage 2-Stage Service Manual

Carefree of Colorado

Programming the RF Receiver for a Remote

When adding or replacing a remote control or receiver, it is necessary to program the transmitter and
receiver.
1. Power to the control box must be on.
2. Locate the receiver box.
3. Press and release the "Press to Learn Transmitter" button on the bottom of the receiver. The receiver is in
program mode when the red light comes on.
4. For Single Awning Key FOBS: Press and release the
button on the remote. The red light will go out after the
receiver learns the remote signal.
NOTE: Pressing the stop button will cause the blue up
arrow button to default as the open (extend) function.
If a function button is pressed to train the receiver, it will be
programmed as the open (extend) button.
Pressing the bottom button will program the bottom button
for extend and the top button as retract.
5. For Multiple Awning Remotes: Press and release the
button on the remote. It is recommended to use the
button. The red light will go out after the receiver learns the
remote signal.
CAUTION
When the receiver learns the transmitter
signal, the system will perform the operation of the button
pressed. Example: Pressing an "Extend" button during
the learning phase will cause the awning to extend when
the receiver learns the signal.
unexpected movement by the awning.
6. Repeat for each additional remote.
OPERATIONAL NOTES:

The transmitter and receiver operate on a frequency of 433MHz.

The receiver exits the program mode after ten seconds.

If the light does not come on in step 2, the memory is full and must be cleared. If the light still does not come
on, check the continuity of the cord between the boxes and repair or replace as required. Pin 1 of the 1
connector goes to pin 1 of the 2

If the light does not go out above, the receiver knows the transmitter signal or the battery in the Remote
needs to be replaced.

To clear the memory:
light should be OFF for the full 5 seconds then come on.

The receiver may be programmed for up to 5 remotes. Additional remotes may be ordered separately.
052588-301r4
Service Manual
Use caution to avoid
nd
connector etc.
the receiver learn button. While holding the button, the indicator
PRESS AND HOLD
STOP
Example:
Indicator
ANY
STOP
Stop
Single
M 2-S
IRAGE
RR
UP
Program
Light Button
Receiver
Stop
Dual Quad
Remotes
TAGE
Stop
M2014
st
5