Programming The Remote Receiver - Carefree Eclipse Owner's Manual

Carefree of Colorado
P
ROGRAMMING THE
When adding or replacing a remote control, it is necessary to program the
transmitter and receiver.
Stop
1. Power to the control box must be on.
2. Locate the receiver box.
3. Press and release the "Press to Learn Transmitter" button on the bottom of the
receiver. The receiver is in program mode when the red light comes on.
4. Press and release the
after the receiver learns the remote signal.
NOTE: Pressing the stop button will cause the blue up arrow button to
default as the close (retract) function.
If a function button is pressed to train the receiver, it will be programmed
as the close (retract) button. Example: Pressing the bottom button will
program the bottom button for retract and the top button as extend.
OPERATIONAL NOTES:

The transmitter and receiver operate on a frequency of 433MHz.

The receiver exits the program mode after ten seconds.

If the light does not come on in step 2, the memory is full and must be cleared.

If the light does not go out above, the receiver knows the transmitter signal
or the battery in the Remote needs to be replaced.

To clear the memory:
seconds. While holding the button, the indicator light should be OFF for the
full 5 seconds then come on.

The receiver may be programmed for up to 5 remotes. Additional remotes
may be ordered separately.
6
R R
EMOTE ECEIVER
Indicator
Light
button on the remote. The red light will go out
STOP
PRESS AND HOLD
RR
UP
Program
Button
DR020
the receiver learn button for 5