Table of Contents
Advertisement
Carefree of Colorado
Installing the Remote Receiver
1.
Determine the location of the optional RF receiver:
1.1 Do not mount the unit near heat producing elements such as LP appliances or engine exhaust
components.
1.2 For best reception, do not mount the unit near or on a metal surface.
1.3 Mount the unit with the antenna pointing up.
1.4 The included cable is approximately 60 inches
long. Mount the unit close enough to the control
box so that the cord can be connected without
stressing the connections.
1.5 Allow room below the box to access the connector
jack, programming button and indicator light.
2.
Position the control box and secure using two (2) #6 x
1/2" screws.
NOTE: If the box is mounted on a surface that is less that 1/2" thick, the screws will protrude through
the opposite side of the surface.
3.
Connect the cable to the receiver.
4.
If using the Ignition Lockout Sensor, route the cable to the splitter and connect. If not using the sensor
connect the cable directly to the control box
Programming the Receiver
These instructions apply to the current 433 MHz configuration of the
remote and receiver. For older versions (418 MHz) refer to the Eclipse
Service Manual.
1. Power to the control box must be on.
2. Press and release the "Press to Learn Transmitter" button on the bottom
of the receiver box. The receiver is in program mode when the red light
comes on.
3. Press and release the stop button on the remote. The red light will
go out after the receiver learns the remote signal.
NOTE: Pressing the stop button will cause the blue up arrow button to default as the close (retract)
function.
If a function button is pressed to train the receiver, it will be programmed as the close (retract) button.
Example: Pressing the bottom button will program the bottom button for retract and the top button as
extend.
4. Repeat for each additional remote.
O
N
:
PERATIONAL
OTES
Transmitter and receiver operate on a frequency of 433 MHz.
The receiver exits the program mode after ten seconds.
If the light does not come on above, the memory is full and must be cleared. If the light still does not come on,
check the continuity of the cord between the boxes and repair or replace as required. Pin 1 of the 1
nd
goes to pin 1 of the 2
If the light does not go out in above, the receiver already knows the transmitter's signal or the battery in the
remote needs to be replaced.
To clear the memory:
should be OFF for the full 5 seconds then come on.
The system may be programmed for up to 5 remotes. Additional remotes may be ordered separately.
052540-031r4
Installation Manual
connector etc.
the transmitter learn button. While holding the button, the indicator light
PRESS AND HOLD
Adjustable T
Screw, Truss Head
#6 x 1/2 (qty: 2)
Stop
Indicator
'
DR
RAVEL
R WITH
4 3/16"
3 7/8"
1"
DR022
RR
UP
Program
Light
Button
DR020
st
connector
9
Advertisement
Table of Contents
