Programming The Remote Receiver; Operational Notes - Carefree APEX Service Manual

APEX
P
ROGRAMMING THE
Early transmitters & receivers operate on a frequency of 418MHz. Models for
2007 & on operate on 433MHz. The transmitter and receiver frequencies must
match. Frequency identification is described under the operational notes below.
1. Power to the control box must be on.
2. Press and release the "Press to Learn Transmitter" button on the bottom of the
receiver box. The receiver is in program mode when the red light comes on.
3. For Gray Button Key FOBS & Multiple Awning Remotes: Press and release
button on the remote. It is recommended to use the
ANY
light will go out after the receiver learns the remote signal.
NOTICE
When the receiver learns the transmitter signal the system
will perform the operation of the button pressed. Example: Pressing an
"Extend" button during the learning phase will cause the awning to extend when the receiver learns
the signal. Use caution to avoid unexpected movement by the awning.
4. For Key FOBS w/ Antenna: Press and release the
after the receiver learns the remote signal.
NOTE: Pressing the stop button will cause the blue up arrow button to default as the open (extend) function.
If a function button is pressed to train the receiver, it will be programmed as the open (extend) button.
Example: Pressing the bottom button will program the bottom button for extend and the top button as retract.
5. Repeat for each additional remote.

Operational Notes:

a. Transmitter and receiver must match in frequency (418 MHz or 433 MHz).
Key FOBs:

The gray button Key FOBS are
marked with a label for 418MHz or
433MHz.

Key FOBS w/ antenna are 433MHz.

Multiple awning remotes
"Stop All" button are 418 MHz.

Multiple awning remotes
All" button are 433 MHz
Receivers:

418 MHz receivers are marked
"RR24".

433 MHz receivers marked "RR"
Version-1 can only be used with the
433 MHz gray button Key FOB.

433 MHz receivers marked "RR" Version-2 can be used with either of the 433 MHz Key FOBs.

If replacing the remote receiver, version 5 is compatible with 433MHz key fobs versions 2 thru 5. If the key
fob is an older version, it will be necessary to replace the key FOB.
b. The receiver exits the program mode after ten seconds.
c. If the light does not come on above, the memory is full and must be cleared.
d. If the light does not go out above, the receiver already knows the transmitter's signal or the battery in the
remote needs to be replaced.
e. To clear the memory:
should be OFF for the full 5 seconds then come on.
f. The system may be programmed for up to 5 remotes. Additional remotes may be ordered separately.
4
Service Manual
R R
EMOTE ECEIVER
a
WITHOUT
a "Stop
WITH
the transmitter learn button. While holding the button, the indicator light
PRESS AND HOLD
button. The red
STOP
button on the remote. The red light will go out
STOP
Rear Label
FCC ID OJM-CMD-KEYX-XXX
or
418MHz
315MHz 433MHz
418 MHz
RR24
RR24
UP
418 MHz 433 MHz
RF Receiver
Carefree of Colorado
Indicator
Light
FCC ID OJM-CMD-KEYX-XXX
433MHz
315MHz 418MHz
433 MHz Versions 2-5
RR
Version 1
RR RR
UP
433 MHz
052522-301r11
UP
Program
Button
DR020
433 MHz
RR
Version 5
UP
DR026a