Installing The Rf Remote Receiver; Programming The Receiver; Operational Notes - Carefree MIRAGE Installation Manual

Carefree of Colorado
I RF R
NSTALLING THE
1. Determine the location of the optional RF receiver:
1.1 Do not mount the unit near heat producing elements
such as LP appliances or engine exhaust components.
1.2 For best reception, do not mount the unit near or on a
metal surface.
1.3 Mount the unit with the antenna pointing up.
1.4 The included cable is approximately 60 inches long.
Mount the unit close enough to the splitter or control box
so that the cord can be connected without stressing the
connections.
1.5 Allow room below the box to access the connector jack, programming button and indicator light.
2. Position the control box and secure using two (2) #6 x 1/2" screws.
NOTE: If the box is mounted on a surface that is less that 1/2" thick, the screws will protrude
through the opposite side of the surface.
3. Connect the cable to the receiver.
NOTE: If the Lock-Out Sensor is not installed, the Receiver cable is connected directly to the
"EYE" connector of the control box.
4. Route the cable to the splitter; or, to the control box and connect to "EYE".

Programming the Receiver

When adding or replacing a key FOB it is necessary to
program the receiver for the transmitter
1. Power to the control box must be on.
2. Press and release the "Press to Learn Transmitter" button on
the bottom of the receiver box. The receiver is in program
mode when the red light comes on.
3. Press and release the stop button on the remote. The red
light will go out after the receiver learns the remote signal.
NOTE: Pressing the stop button will cause the blue
up arrow button to default as the close
(retract) function.
pressed to train the receiver, it will be
programmed as the close (retract) button.
Example:
program the bottom button for retract and the
top button as extend.
4. Repeat for each additional remote.

Operational Notes:

 Transmitter and receiver operate on a frequency of 433 MHz.
 The receiver exits the program mode after ten seconds.
 If the light does not come on above, the memory is full and must be cleared. If the light still does not come on,
check the continuity of the cord between the boxes and repair or replace as required. Pin 1 of the 1
nd
goes to pin 1 of the 2
 If the light does not go out in above, the receiver already knows the transmitter's signal or the battery in the
remote needs to be replaced.
 To clear the memory:
indicator light should be OFF for the full 5 seconds then come on.
 The system may be programmed for up to 5 remotes. Additional remotes may be ordered separately.
Installation Manual
R
EMOTE ECEIVER
If a function button is
Pressing the bottom button will
connector etc.
the transmitter learn button for 5 seconds. While holding the button, the
PRESS AND HOLD
Figure 10. RR24 RF Receiver.
Stop
Figure 11. RF Receiver.
8
Mirage
RR24
UP
#6 x 1/2
Screw (2)
3 7/8"
UP
Indicator Program
Light Button
st
connector
052979-003r5
4 3/16"
1"
RTA034
DR020