Table of Contents
Advertisement
Carefree of Colorado
P
ROGRAMMING THE
Early transmitters & receivers operate on a frequency of 418MHz. Models for 2007 &
on operate on 433MHz.
Identifying the transmitter frequency is described under the operational notes below.
1.
Power to the control box must be on.
2.
Press and release the "Press to Learn
Transmitter" button on the bottom of the
receiver box. The receiver is in program mode
when the red light comes on.
3.
For Gray Button Key FOBs:
release the
ANY
recommended to use the
red light will go out after the receiver learns
the remote signal.
4.
For Key FOBS w/ Antenna:
release the
STOP
red light will go out after the receiver learns
the remote signal.
NOTE: Pressing the stop button will cause the blue up arrow button to
default as the close (retract) function.
If a function button is pressed to train the receiver, it will be programmed as
the open (extemd) button.
program the bottom button for extend and the top button as retract.
I
F A FUNCTION BUTTON IS PRESSED DURING THE LEARNING PHASE
PRESSED WILL BECOME THE EXTEND FUNCTION
(
)
FUNCTION
EXTEND
AVOID UNEXPECTED AWNING MOVEMENT
5.
Repeat for each additional remote.
O
PERATIONAL
• Transmitter and receiver must match in
frequency (418 MHz or 433 MHz).
The gray button Key FOBS are marked with a
label for 418MHz or 433MHz frequency. Key
FOBS w/ antenna are 433MHz.
418 MHz receivers are marked "RR24". 433
MHz receivers are marked "RR"
i.
The receiver exits the program mode after ten
seconds.
• If the light does not come on above, the
memory is full and must be cleared.
• If the light does not go out in above, the receiver already knows the transmitter's
signal or the battery in the remote needs to be replaced.
• To clear the memory:
button, the indicator light should be OFF for the full 5 seconds then come on.
• The system may be programmed for up to 5 remotes.
6
R
ECEIVER FOR THE
The transmitter and receiver frequencies must match.
button on the remote. It is
STOP
button on the remote. The
WHEN THE RECEIVER LEARNS THE TRANSMITTER SIGNAL
.
N
:
OTES
PRESS AND HOLD
R
EMOTE
Press and
button. The
Press and
Indicator
Example:
Pressing the bottom button will
CAUTION
. T
HE AWNING WILL THEN PERFORM THE
Stop
Stop
the transmitter learn button. While holding the
UP
Program
Light
Button
,
THE BUTTON THAT IS
. U
SE CARE TO
FCC ID OJM-CMD-KEYX-XXX
418MHz
315MHz
418 MHz
OR
Rear
Label
FCC ID OJM-CMD-KEYX-XXX
315MHz
418MHz
433 MHz
433 MHz
DR020
433MHz
433MHz
DR026
Advertisement
Table of Contents
