Programming The Receiver; Manual Override - Carefree MIRAGE Owner's Manual

Carefree of Colorado
P
ROGRAMMING THE
When adding or replacing a remote
control, it is necessary to program the
transmitter and receiver.
1. Power to the control box must be on.
2. Press and release the "Press to Learn
Transmitter" button on the bottom of the
receiver box. The receiver is in program
mode when the red light comes on.
3. Press and release the
the remote. The red light goes out after
the receiver learns the remote signal.
NOTE: Pressing the stop button will cause the blue up arrow button to
default as the close (retract) function.
If a function button is pressed to train the receiver, it will be programmed as
the retract button. Example: Pressing the top button will program the top
button for retract and the bottom button as extend.
Remote Operational Notes:
 Transmitter and receiver operate on frequency 433 MHz.
 The receiver exits the program mode after ten seconds.
 If the light does not come on, the memory is full and must be cleared.
 To clear the memory:
button, the indicator light should be OFF for the full 5 seconds then come on.
 If the light does not go out during programming, the receiver already knows the
transmitter's signal or the battery in the remote needs to be replaced.
 The system may be programmed for up to 5 remotes. Additional remotes may be
ordered separately.
M O
ANUAL VERRIDE
If 110V power is not available, the awning can still be safely retracted using the manual
override. The bypass may be accessed from inside the case on the motor housing or
through the top of the case above the motor housing.
To use the top bypass access: Remove the screw
and well nut that is used to secure the end cap.
To use the inside bottom access: The awning
must be open of 6-8" to access the override.
1. Chuck the supplied 7mm hex key into a 3/8"
battery powered drill.
2. Insert the hex key into the manual override
on the awning. For the top access, it will be
necessary to locate the hex by feel; it is not
visible with the key inserted in the hole.
3. Operate the drill in the forward (clockwise)
direction to close the awning. Reverse the
drill to open the awning.
NOTE: When using the bottom override, the awning can only be closed within 6-8".
It will be necessary to use the top access to close the awning completely.
4. When done, return the screw and well nut to the top of the case if removed.
6
R
ECEIVER
button on
STOP
the transmitter learn button. While holding the
PRESS AND HOLD
Stop
Indicator
Light
Top View
Remove Screw and
Rubber Well Nut to
Access Manual
Overide (7mm Hex)
Bottom View

Manual Override

(7mm Hex)
RR
UP
Program
Button
DR020
Wall
Wall
MIRAGE028