Installing The Remote Receiver - Carefree PARAMOUNT Installation Manual

Carefree of Colorado
I R
NSTALLING THE
1. Determine the location of the RF receiver:
1.1 Do not mount the unit near heat producing elements such as LP appliances or engine exhaust
components.
1.2 For best reception, do not mount the unit near or on a metal surface.
1.3 Mount the unit with the antenna pointing up.
1.4 The included cable is approximately 60 inches long.
Mount the unit close enough to the splitter or control
box so that the cord can be connected without
stressing the connections.
1.5 Allow adequate room below the box to access the
connector jack, programming button and indicator
light.
2. Position the control box and secure using two (2) #6 x 1/2" screws.
NOTE: If the box is mounted on a surface that is less than 1/2" thick, the screws will protrude through
the opposite side of the surface.
3. Connect the cable to the receiver.
4. Route the cable to the control box and connect to any open "EYE" port.
Programming the Receiver for the Remote
1. Power to the control box must be on.
2. Press and release the "Press to Learn Transmitter" button on the bottom
of the receiver box. The receiver is in program mode when the red light
comes on.
3. Press and release the
out after the receiver learns the remote signal.
CAUTION
system will perform the operation of the button pressed. Example: Pressing
an "Extend" button during the learning phase will cause the awning to
extend when the receiver learns the signal. Use caution to avoid unexpected
movement by the awning.
4. Repeat steps 2 and 3 for each additional remote.
OPERATIONAL NOTES:

Transmitter and receiver operate on a frequency of 433MHz.

The receiver exits the program mode after ten seconds.

If the light does not come on in step 2, check the continuity of the cord between the boxes and repair or
replace as required. Pin 1 of the 1
come on, the memory is full and must be cleared.

If the light does not go out in step 3, the receiver already knows the transmitter's signal or the battery in
the remote needs to be replaced.

To clear the memory:
indicator light should be OFF for the full 5 seconds then come on.

The system may be programmed for up to 5 remotes. Additional remotes may be ordered separately.
052548-001r11
Installation Manual
R
EMOTE ECEIVER
button on the remote. The red light will go
STOP
When the receiver learns the transmitter signal, the
st
connector goes to pin 1 of the 2
the transmitter learn button. While holding the button, the
PRESS AND HOLD
#6 x 1/2
Screw (2)
Indicator
Light
nd
connector etc. If the light still does not
P
ARAMOUNT
4 3/16"
UP
1"
3 7/8"
RTA034
UP
Program
Button
DR020
8