Programming The Remote Receiver; Operational Notes - Carefree ECLIPSE Owner's Manual

P
ROGRAMMING THE
When adding or replacing a remote control, it is necessary to program the
transmitter and receiver.
1. Awning power must be on.
2. Press and release the "Press to
Learn Transmitter" button on the
bottom of the receiver box. The
receiver is in program mode
when the red light comes on.
3. Press and release the
button on the remote. The red
light will go out after the receiver
learns the remote signal.
NOTE: Pressing
button will cause the blue up
arrow button to default as the
close (retract) function.
If a function button is pressed to train the receiver, it will be programmed as
the retract button. Example: Pressing the top button will program the top
button for retract and the bottom button as extend.
O
PERATIONAL
 Transmitter and receiver operate on frequency 433 MHz.
 The receiver exits the program mode after ten seconds.
 If the light does not come on, the memory is full and must be cleared.
 To clear the memory:
button, the indicator light should be OFF for the full 5 seconds then come on.
 If the light does not go out during programming, the receiver already knows the
transmitter's signal or the battery in the remote needs to be replaced.
 The system may be programmed for up to 5 remotes. Additional remotes may be
ordered separately.
R
EMOTE
STOP
the stop
N :
OTES
PRESS AND HOLD
R
ECEIVER
the transmitter learn button. While holding the
E
CLIPSE
7