Redarc TVMS Rogue Manual page 5

8. RISK OF FIRE — Do NOT install this product in the same compartment where flammable substances are
stored, such as petrol/gasoline or Liquefied Petroleum Gas (LPG).
Incorrect handling or disassembly/reassembly may result in a risk of fire. Any attempt to disassemble/
reassemble the TVMS Rogue, or make unapproved repairs or modifications will void the warranty and the
user's authority to operate the TVMS Rogue.
9. DO NOT expose the TVMS Rogue to temperatures beyond the published limits.
10. DO NOT operate the TVMS Rogue beyond the published ratings. Doing so may result in damage to the
TVMS Rogue, fire, explosion and burns/personal injury.
11. If any mechanism or part of the TVMS Rogue becomes broken or damaged, discontinue use immediately.
12. When using the REDARC Configurator App, DO NOT configure important vehicle safety features (such as
driving lights or power awnings) in such a way that they may turn Off/On unintentionally while the vehicle is
in motion.
13. Use suitable Personal Protective Equipment (PPE) when operating power tools.
CAUTION
1. The system should not be used by persons under the age of 18, or those with reduced physical, sensory or
mental capabilities or lack of experience and knowledge unless they are supervised and under instruction.
2. Selecting the wrong cable or fuse size could result in harm to the installer or user and/or damage to the
battery or other equipment installed in the system. The installer is responsible for ensuring that the correct
cable type and fuse sizes are used when installing the TVMS Rogue.
3. Cabling must be installed in protected areas away from heat sources, sharp objects or over/through parts of
the vehicle that move during operation or maintenance. Supplementary protection such as conduit may be
required, especially when installing or routing in the engine bay.
4. Do NOT use this product to control safety critical devices or those that could cause harm if operated remotely
(for example fume exhaust fans or lifters). Only operate devices with moving parts when you have a clear line
of sight to the moving parts.
5. NEVER connect the TVMS Rogue output ground to chassis ground. Either connect the TVMS Rogue
output ground to the negative of a load OR connect chassis ground to the negative of a load and leave the
TVMS Rogue output ground unconnected.
NOTICE
1.
Do NOT parallel the outputs on the Output Loom — it could cause the TVMS Rogue to not function as
expected and may trigger a Fault.
2.
Do NOT connect computers or IT equipment to R-Bus Network (B) on the TVMS Rogue. This may damage
the Main Unit internal components.
Warnings and Safety Instructions | 5