Warnings And Safety Instructions - Redarc TVMS Rogue Manual

12 v 40 a control and distribution module
Hide thumbs Also See for TVMS Rogue:
Table of Contents

Advertisement

WARNINGS AND SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS — this manual contains important safety instructions. Do not operate the system
unless you have read and understood this manual. REDARC recommends that the TVMS Rogue be installed
by a suitably qualified person. It is the installer's responsibility to ensure that their installation complies with any
applicable legal and regulatory requirements.
Disclaimer: REDARC accepts no liability for any injury, loss or property damage which may occur from the
improper or unsafe installation or use of its products.
SAFETY MESSAGE CONVENTIONS
Safety messages in this manual include a signal word to indicate the level of the hazard as follows:
WARNING: Indicates a potentially hazardous situation which could result in death or serious injury to the operator
or to bystanders.
CAUTION: Indicates a potentially hazardous situation which may result in moderate or minor injury to the
operator or to bystanders.
NOTICE: Indicates a situation that may cause equipment damage.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
When using this product, basic precautions should always be followed, including the following:
1.
These products should not be used for any medical purposes, life sustaining equipment, safety applications,
or any application where equipment failure can cause injury, death, fires or any other hazard.
2.
Do NOT put fingers or hands into the product.
3.
Do NOT use the TVMS Rogue if damaged or modified. Damaged or modified products may exhibit
unpredictable behaviour resulting in fire, explosion or risk of injury.
4.
No user serviceable parts inside. Do NOT attempt servicing this product.
5.
Risk of explosive gases: Working in the vicinity of a battery is dangerous. Batteries may generate
explosive gases during normal operation. Prevent flames and sparks, and provide adequate ventilation
especially during charging.
6.
To reduce risk of battery explosion, follow these instructions and those published by the battery manufacturer
and manufacturer of any equipment you intend to use in vicinity of the battery.
PERSONAL PRECAUTIONS
1.
Consider having someone close-by to come to your aid if you are working near a lead-acid battery.
2.
Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.
3.
Wear complete eye protection and clothing protection. Avoid touching eyes while working near battery. If
battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters eye, immediately
flood eye with running cold water for at least 10 minutes and get medical attention immediately.
4.
Do NOT drop metal tools onto a vehicle battery. Doing so might cause the battery to spark or might short-
circuit the battery or other electrical parts, which may cause an explosion.
5.
NEVER smoke or allow a spark or flame in vicinity of battery or engine.
6.
Remove personal metal items such as rings, bracelets, necklaces, and watches before working with a vehicle
battery. A vehicle battery can produce a short-circuit current high enough to weld a ring or the like to metal,
causing a severe burn.
7.
Have servicing performed by a qualified repair person using only identical replacement parts. This will ensure
that the safety of the product is maintained.
4 | Warnings and Safety Instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TVMS Rogue and is the answer not in the manual?

This manual is also suitable for:

Tvms1240Tvms1240kit02-naTvms1240kit01Tvmscombokit1-na

Table of Contents