CARE AND MAINTENANCE
Do not use solvents, alcohol, or domestic cleaning products to clean the TVMS Rogue. If sand,
grit, or dirt accumulate on the Main Unit, wipe it clean with a slightly damp cloth.
Do not allow the TVMS Rogue to come into contact with corrosive substances.
Periodically check that all connections are firm, and that all cables are adequately managed.
Parts of the system may have moved as a result of repeated vibration, particularly if the vehicle
has been travelling on uneven/corrugated road surfaces.
TROUBLESHOOTING
GENERAL TROUBLESHOOTING
If you experience any of the listed problems, follow the recommended actions in order until the
problem is resolved — all steps may not be needed to resolve the problem.
If the problem persists after completing all of the recommended actions, contact REDARC directly,
or your local REDARC Distributor.
The Status LED is flashing or solid red
There is a Fault. Refer to
individual Faults.
The RedVision
Display will not connect to the RedVision
®
1. Make sure the smartphone is within 5 metres (16'5") of the RedVision
2. Check that Bluetooth is enabled on your device.
3. Remove the RedVision
also from the Bluetooth devices list in your smartphone settings.
4. Delete all pairings from the RedVision
5. Unplug all RJ45 R-Bus Cables from the RedVision
6. Turn your smartphone Off and then On.
7. Re-pair the RedVision
Delete All Display Pairings
1. On the RedVision Display, navigate to Display Settings.
2. Press the Bluetooth
3. Press the Delete Soft Key (
to clear all paired devices.
page 41
for more detailed information and ways to identify and resolve
Display 'DISP4300' from the Devices list in the RedVision
®
Display. See
®
Display and smartphone.
®
Soft Key (
) to display the Bluetooth Pairing Advertising screen.
®
) then press the OK Soft Key (
App/Configurator App
®
Display.
®
'Delete All Display
Pairings' (page 41).
Display and then reconnect them again.
®
) to confirm that you want
Care and Maintenance | 41
App and
®
Need help?
Do you have a question about the TVMS Rogue and is the answer not in the manual?