Table of Contents
Advertisement
MOUNTING STEPS
WARNING: Use suitable Personal Protective Equipment (PPE)
when operating power tools.
NOTICE: Do NOT modify the plastic housing or mounting holes in any way. Modification to the
unit will void the warranty.
1. Confirm that the clearances around the TVMS Rogue Main Unit are adequate; see
Clearances' (page 15).
2. If clearance/pilot holes need to be drilled, place the TVMS Rogue in its final position and
carefully mark the centre of each mounting hole. For centre dimensions of mounting holes,
see
'General
Specifications' (page 43).
3. Drill the clearance/pilot holes. De -burr the drilled holes and clear away swarf. Touch up any bare
metal surfaces that have been exposed with a rust-inhibitor (e.g. primer).
4. Fasten the TVMS Rogue in place, applying a washer in between the fastener and the plastic
housing. Do not over-tighten the fasteners, as this could damage the Mounting Holes or plastic
housing of the Main Unit.
16 | Installation — Mounting
'Mounting
Advertisement
Table of Contents
Need help?
Do you have a question about the TVMS Rogue and is the answer not in the manual?