4-5-22.Removal Of High Voltage Unit (Hv1) - Minolta QMS PageWorks/Pro 1100 Service Manual

4-5-22. Removal of High Voltage Unit (HV1)
1. Remove the Right Cover, Left Cover, Top Cover and Rear Cover.
2. Remove the Power Unit (PU1).
3. Remove the High Voltage Unit (HV1). (3 screws, 1 connector)
NOTE:When installing the High Voltage Unit (HV1), direct care to the fol-
lowing points:
1. Attach the bracket to the rear side of the HV1 as shown in Fig.
1.
2. Confirm that all contacts (4 locations) are in contact without
failure.
Contacts
High Voltage Board
(HV1)
4121s066
Fig. 1
4121s079
65
Bracket