5. Remove the Lamp holder. (2 screws)
6. Pull out the Heater Lamp.
NOTE: When reinstalling the lamp, position the voltage mark on the fus-
ing drive gear side. Be sure not to touch the lamp surface with
bare hands.
Heater Lamp
voltage mark
4121s059
7. Remove the fusing drive gear from the Heat roller.
8. Remove the Heat Roller from the Fusing Unit.
(1) Slide the roller to the right.
(2) Swing out the left end.
(3) Slide out the right end.
NOTE: In order not to scratch the surface of the Heat Roller with the
Fusing Separators, lift the Separators as much as possible when
removing or installing the roller.
4121s060
(2)
(3)
(1)
60
1305
3704