Table of Contents
Advertisement
List Sweep
By using the list sweep function, the channel can apply your desired waveform, for
example as shown in
value.
This function can be used in both the DC voltage/current output range and the
pulse voltage/current output range.
The source output and measurement timing is controlled by the trigger system.
And the interval can be set to a constant value if the trigger type is set to TIMER.
The source output and measurement can be performed in 10 s minimum interval.
To set these trigger parameters, see
interval can be set by the Period parameter. The number of output values can be
set by the Count parameter.
To set the source output values, use the List Sweep dialog box. See
Setup" on page
Figure 6-4
the output waveform.
Figure 6-4
Keysight B2961B/B2962B User's Guide, Edition 1
Figure
118.
shows an example setup of the List Sweep dialog box with an image of
List Sweep Dialog Box
6-4, and measure voltage or current at each output
"Trigger Parameters" on page
Function Details
List Sweep
125. The
"List Sweep
197
Advertisement
Chapters
Table of Contents
