To Set Source Output - Keysight Technologies B2961B User Manual

To Set Source Output

This section describes the following source output operations.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Keysight B2961B/B2962B User's Guide, Edition 1
"To Set Source Output Mode"
"To Apply DC Voltage/Current"
"To Stop Source Output"
"To Set Limit Value"
"To Set Output Function"
"To Set Output Range"
"To Set Programmable Output Resistance"
"To Set Pulse Output"
"To Set List Sweep Output"
"To Set Source Output Trigger Parameters"
"To Set Source Wait Time"
"To Set Output Filter"
"To Set Connection Type"
"To Set Low Terminal State"
"To Enable or Disable High Capacitance Mode"
"To Enable or Disable Over Voltage/Current Protection"
"To Specify Output-Off Status"
"To Enable or Disable Automatic Output-On Function"
"To Enable or Disable Automatic Output-Off Function"
"To Set Ranging Mode of the Sweep Source"
"To Set Sweep Direction"
"To Set Source Output Value after Sweep"
Front Panel Operations
To Set Source Output
169