To Execute Measurement; To Set Measurement Mode; To Perform Spot Measurement - Keysight Technologies B2961B User Manual

Front Panel Operations

To Execute Measurement

To Execute Measurement
This section describes the following measurement operations.
•
•
•
•
•
•
•
•

To Set Measurement Mode

1. For the Single view, press the Measure assist key. For the Dual view, press the
2. Press AMPS (I) for the current measurement, VOLTS (V) for the voltage

To Perform Spot Measurement

1. Set the measurement mode (see
2. Set the output voltage or current (see
3. Press the On/Off switch for channel 1 or 2 (Ch1 or Ch2).
4. Press the Trigger key.
180
"To Set Measurement Mode"
"To Perform Spot Measurement"
"To Stop Measurement"
"To Set Measurement Time"
"To Perform Sweep Measurement"
"To Set Measurement Trigger Parameters"
"To Set Measurement Wait Time"
"To Enable or Disable Resistance Compensation"
Ch1 Measure or Ch2 Measure assist key.
measurement, OHMS (R) for the resistance measurement, WATTS (P) for the
power measurement, or %LIMIT (%) for the percent-to-Limit measurement.
page 170).
The channel starts the specified voltage/current output. While the switch is
turned green, the channel continues the output and changes the value
immediately if it is changed.
The spot measurement is performed.
"To Set Measurement Mode" on page
"To Apply DC Voltage/Current" on
Keysight B2961B/B2962B User's Guide, Edition 1
180).