Trigger Configuration Dialog Box - Keysight Technologies B2961B User Manual

Trigger Configuration Dialog Box

This dialog box is used to set the trigger parameters in detail. Note that the
overlapped parameter values are ignored and replaced with the settings made on
the Single view. See
Ch
Layer
Action
Count
Bypass
Keysight B2961B/B2962B User's Guide, Edition 1
Softkey label
Ch 2 Selects channel 2 only.
Selecting the channel executes Initiate, Abort, or Immediate for the specified device
action of the specified channel.
"Trigger Parameters" on page
Only on 2-channel models. Channel 1 (Ch 1) or 2 (Ch 2)
This field specifies the channel set by this dialog box.
Specifies the layer or device action set by this dialog box.
ARM: Arm layer
TRIGGER: Trigger layer
ACTION: Device action
For ACTION, the available parameters are Ch, Layer, Action,
and Trigger Output.
Specifies the device action type set by this dialog box.
TRANS.: Transient (source output) device action
ACQ.: Acquire (measurement) device action
Count, 1 to 100000 or INF. (infinity), for the action specified by
the Ch, Layer, and Action parameters
Bypass, ON or OFF
Bypass = ON enables the bypass only for the first passage to
the event detector for the action specified by the Ch, Layer, and
Action parameters.
Bypass = OFF disables the bypass.
Front Panel Reference
Trigger Key Group
Description
125.
141