Table of Contents
Advertisement
2. Set each parameter in the Measure column.
3. To apply the settings, press Apply.
To Enable or Disable Resistance Compensation
1. Press the Config > Measure > R Compen function keys.
2. For the 2-channel models, specify the channel to which the setting change is
3. To enable the resistance compensation, press ON.
Keysight B2961B/B2962B User's Guide, Edition 1
The Wait Control dialog box opens.
To apply the settings and close the dialog box, press OK.
To cancel the setting change, press the Cancel/Local key.
applied by using the following function keys.
ALL: Channels 1 and 2 (Ch 1 and Ch 2)
Ch 1: Channel 1 (Ch 1) only
Ch 2: Channel 2 (Ch 2) only
To disable it, press OFF.
To cancel the setting change, press the Cancel/Local key.
Front Panel Operations
To Execute Measurement
183
Advertisement
Chapters
Table of Contents
