Getting Started With The Diagnostic Flash Demonstration; Setting The Default Jumper Settings; Installing Compactflash Card, Usb Uart Cable, And 12V Power - Xilinx Spartan-6 FPGA SP605 Getting Started

Getting Started with the Diagnostic Flash Demonstration

Getting Started with the Diagnostic Flash Demonstration
In addition to the BRD demonstration, a board diagnostic built-in system test (BIST) can
also be run that provides an overview of the SP605 board features. The BIST exercises some
of the board features, including testing the UART, flashing the LEDs, reading the switches,
and testing the Flash memory, DDR3 component memory, IIC bus, Ethernet PHY, and DVI
interface.

Setting the Default Jumper Settings

Figure 1-13
CompactFlash memory card location, and 12V power connection.
As shown in
both pins; 3-pin headers J19 and J22 should have jumpers installed across pins 1–2.
Headers J9, J10, J13, J45, J47, J48, J49, J58, and J60 should have no jumpers installed.
X-Ref Target - Figure 1-13
USB UART
Mini-B To J23
J46
Figure 1-13: Default Jumper Settings, Cable Connections, and CompactFlash Memory Connection

Installing CompactFlash Card, USB UART Cable, and 12V Power

1.
2.
3.
18
highlights the default jumper settings, USB Mini-B JTAG connection,
Figure 1-13, 2-pin headers J44 and J46 should have jumpers installed across
CompactFlash Card and
System ACE CF Controller
J19
J44
J22
Install the CompactFlash memory card.
Connect the Mini-B USB cable to the USB connector marked J23 (USB UART), and
connect the USB A end of the cable to the PC.
Plug in the power adapter to local AC power. Plug the 12V power cable into the board
connector on J18. Turn on the power by switching the SW1 to the ON position.
www.xilinx.com
Power On
Switch
12V
Power
J18
UG525_13_030811
Spartan-6/SP605 Getting Started Guide
UG525 (v1.3) March 29, 2011