Guide Through This Manual - Siemens SINAMICS G120 Function Manual

Introduction

1.2 Guide through this manual

1.2 Guide through this manual
Chapter
Description (Page 13)
Interfaces (Page 75)
Commissioning (Page 105)
Servicing and maintenance
(Page 179)
Alarms, faults and system
messages (Page 187)
System properties
(Page 209)
Appendix (Page 211)
12
In this chapter, you will find answers to the following questions:
What safety functions does my inverter have?
•
In which applications are the safety functions of my inverter not permitted?
•
• How must I select and deselect the safety function?
How do the inverter and motor respond when the safety function is active?
•
How do the safety functions mutually influence one another?
•
How many fail-safe inputs does my inverter have?
•
How do I have to wire up the fail-safe inputs of my inverter?
•
What do I have to observe if the wiring extends beyond the control cabinet?
•
How do I configure the communication of my inverter via PROFIsafe?
•
How are the control words and status words assigned in PROFIsafe?
•
What approach to commissioning should I take?
•
What tool do I need for commissioning?
•
How do I transfer the parameters of the safety functions to other inverters?
•
How do I reset my inverter to the factory setting?
•
How do I check the safety functions after commissioning?
•
What safety function settings must I document?
•
When do I have to recommission the safety functions of my inverter after I have replaced
•
defective components?
What do I have to check after making a replacement?
•
What is the meaning of the signal states of the LED on my inverter?
•
How do the inverter and motor respond to faults when the safety function is active?
•
How do I acknowledge safety function faults?
•
• What is the meaning of the alarms and faults, which are assigned to the safety
functions?
How long does it take for my drive to respond when selecting a safety function?
•
How long does it take for my drive to respond when the safety function is active and the
•
motor malfunctions?
What are the probabilities of failure of the safety functions of my inverter?
•
According to which standards are the safety functions of my inverter certified?
•
As machine manufacturer or company operating a machine, what standards and
•
regulations must I observe?
Where can I find more information on my inverter?
•
Safety Integrated Function Manual, SINAMICS G120 and G120C
Function Manual, 01/2011, FW 4.4, A5E03052391B AB