Further Steps - Siemens SINAMICS G120 Function Manual

Commissioning
4.6 Extended Safety
● When you use the data set changeover CDS, you must delete the multiple assignment of
4.6.3.15

Further steps

● Commission the standard inverter functions by following the operating instructions. The
● Perform an acceptance test for the safety functions:
160
Figure 4-8 Remove pre-assignment of digital inputs DI 4 and DI 5
the digital inputs for all CDS.
link to the operating instructions can be found in the section Manuals for your inverter
(Page 229).
– Document your settings in an acceptance report.
– Check whether the safety functions are functioning correctly in your application.
– The instructions for the acceptance test can be found in the section Acceptance test -
Completion of commissioning (Page 164).
Safety Integrated Function Manual, SINAMICS G120 and G120C
Function Manual, 01/2011, FW 4.4, A5E03052391B AB