How To Use This Manual - Siemens BT300 Operator's Manual

How to Use this Manual

Siemens Industry, Inc.
About This Manual
This manual is written for the owner and user of the Siemens BT300 Bypass. It is
designed to help you become familiar with the Siemens BT300 Bypass and its
applications.
This section covers manual organization, document conventions and symbols used in
the manual, how to access help, related publications, and any other information that
will help you use this manual.
Document Organization
This manual contains the following sections:
Safety Instructions provides general guidelines for your safety and to prevent
●
equipment damage.
● Bypass Overview describes both the Conventional and Electronic Bypass devices.
Startup Procedures describes the precautions, installation, preparation, and
●
commissioning procedures.
Wiring Diagrams for power and control wiring of the Bypass.
●
Operation (Electronic Bypass Only) describes the use of the electronic Bypass.
●
Application Features (Electronic Bypass Only) describes the electronic Bypass
●
extended features.
Troubleshooting provides guidelines for troubleshooting the Bypass.
●
Technical Information provides product numbers, power ratings, technical data,
●
and ordering information for accessories and replacement parts.
Document Conventions
The following table lists conventions to help you use this manual in a quick and
efficient manner.
Convention
Numbered Lists (1, 2, 3...) indicate a
procedure with sequential steps.
Conditions that must be completed or
met before beginning a task are
designated with a ⊳.
Intermediate results (what will happen
following the execution of a step), are
designated with a ⇨.
Results, which inform the user that a task
was completed successfully, are
designated with a ⇨.
Actions that should be performed are
specified in boldface font.
Error and system messages are
BT300 Bypass Operator's Manual
How to Use this Manual
Reference Documents
Examples
1. Turn OFF power to the field panel.
2. Turn ON power to the field panel.
3. Contact the local Siemens Industry
representative.
⊳Composer software is properly installed.
⊳A Valid license is available.
1. Select Start > Programs > Siemens > GMS >
Composer.
⇨The Project Management window displays.
2. Open an existing project or create a new one.
⇨The project window displays.
Type F for Field panels.
Click OK to save changes and close the dialog box.
The message Report Definition
5
DPD01391
2016-08-05