Table of Contents
Advertisement
Secure the processor by pressing the ZIF handle back to the
8.
closed position.
Change the settings of the jumpers so that they are correct
9.
for the type of processor you installed. (See the "CPU type
jumper settings" table on page 4-8.) You may also need to
change the setting of jumpers JP24 and JP25 to match the
processor clock speed.
If you installed a processor with a different voltage
(check the table under "Processor Upgrades" in
Appendix A), change the settings of the CPU voltage
jumper. See the table on page 4-9.
10.
If you are upgrading to a DX, DX2, DX4, or Pentium
OverDrive processor, you must also install a heat sink over
the processor. Follow the instructions included with the
heat sink.
11.
Replace any option cards you removed; see "Installing an
Option Card on page 4-16 for instructions.
12.
Replace the computer's cover as described under "Replacing
the Cover" on page 4-4. Then see "Post-installation
Procedures" (below) for instructions on configuring your
computer with your new processor.
Post-installation
After you install or remove options such as memory modules
or option cards, you must run SETUP to update the computer's
configuration. See Chapter 2 for instructions.
Additionally, you may need to add some commands to your
configuration files. See your operating system documentation
and the manual that came with your optional equipment.
4-26
Installing and Removing Options
Procedures
Advertisement
Table of Contents
