Table of Contents
Advertisement
2. Remove the retaining screw securing the hard disk drive
and mounting plate to the externally accessible drive bays.
Then slide the hard disk drive and mounting plate in the
direction of the arrow, shown below, and lift them out of
the computer.
Remove the four screws securing the mounting plate to the
3.
hard disk drive. You can store the mounting plate and its
screw or replace it in the computer and secure it with the
screw.
4. Wrap the hard disk drive in its original packing materials
and store it along with the four screws.
If you have finished installing or removing drives, replace
5.
the computer's cover, as described in Chapter 4. Then see
Chapter 2 for instructions on defining your new drive
configuration.
Installing and Removing Drives
5-11
Advertisement
Table of Contents
