Table of Contents
Advertisement
If you are installing a high-resolution graphics adapter
card, follow the instructions below to install the adapter
card; then see "Using the SVGA Feature Connector" on
page 4-23 to connect the card to the SVGA feature
connector on the system board.
Caution
Before you install any option cards in your system, make
sure that all the cards together do not draw more current
than the limits listed in Appendix A.
Follow these steps to install an option card:
1. Remove the retaining screw securing the option slot cover
to the computer, as shown below. (Keep the screw to secure
the option card to the computer.)
2. Slide out the slot cover and set it aside. (Store it in a safe
place in case you remove the option card later.)
Installing and Removing Options
4-17
Advertisement
Table of Contents
