Post-Installation Procedures - Epson Progression User Manual

5. Replace the computer's cover as described in Chapter 2; then
see "Post-installation Procedures," below, to update your
configuration.

Post-installation Procedures

After you install or remove a drive, follow the necessary steps
below to make sure your new configuration works properly:
1. Run the SETUP program to configure your computer for your
new drive configuration. See Chapter 2 of the Setup Guide
for instructions.
2. If you installed a hard disk drive that did not receive a
low-level format, you need to format the drive before you
can use it. (All Epson drives are sold already formatted.)
Check the manual that came with the drive to see if it is
already formatted. If not, see Chapter 6 for instructions.
3. If you want to be able to load your operating system from a
new hard disk drive, you need to install it on the drive. See
the documentation that came with your operating system
for instructions.
4. You may also want to test a newly-installed drive. See
Chapter 5 for instructions on using the system diagnostic
program on your Reference diskette to test your drives.
Installing and Removing Drives 4-27