Table of Contents
Advertisement
Installing a Drive in an Externally Accessible Bay
This section explains how to install a drive in an externally
accessible drive bay. It includes steps for the following
procedures:
Attaching the mounting frames to a 3.5-inch drive
Installing the drive
Connecting the cables.
Note
If you are installing a hard disk drive or another IDE device,
be sure its jumper(s) are set correctly for your configuration.
A table in Appendix A lists the master and slave jumper
settings for high-capacity, EPSON-qualified, IDE hard disk
drives. If you need more information, see the documentation
that came with your drive or contact the manufacturer.
Attaching Mounting Frames to the Drive
If you are installing a 3.5-inch wide drive, you need to attach
mounting frames to it so that the drive fits in a 5.25-inch wide
bay. These frames usually come with your drive, but if they
didn't, you can purchase them from a computer supply store.
1. Make sure you have two mounting frames and four screws.
5-12 Installing and Removing Drives
Advertisement
Table of Contents
