Table of Contents
Advertisement
If your system was in Suspend mode, it takes a few moments
for the monitor to display an image and for the hard disk drive
to return to active mode. You'll hear it start again. It takes a few
seconds for the drive to reach its full operating speed and read
or write to the disk.
Note
Some hard disk drives do not support power-saving modes.
Also, the delay caused by the hard disk drive returning to
active mode may cause errors in some applications. If you
have problems, you may want to disable the
Power Down option in SETUP.
Inserting and Removing Diskettes
To insert a diskette into a 3.5-inch drive, hold the diskette with
the label facing up and the shutter leading into the drive, as
shown in the following illustrations. Slide the diskette into the
drive until it clicks into place.
Using Y
3-8
OU
r Computer
Drive
IDE
Advertisement
Table of Contents
