Table of Contents
Advertisement
Post-installation Setup Procedures
After you install or remove options, you need to run the System
Configuration program on your Reference 1 diskette so you can
update your system's configuration information. The program
will automatically update the information about some optional
equipment, such as additional memory or a math coprocessor.
See Chapter 2 for instructions.
If you installed a hard disk drive that has never received a
low-level format, you need to format the disk. Check the
manual that came with your drive, and then, if necessary,
follow the instructions in Appendix B to format your new hard
disk.
You may also want to test a newly-installed option. Some
options come with their own diagnostic test programs, and you
can test the following options with the System diagnostics
program on your Reference 2 diskette:
Serial and parallel ports
Dot matrix printers.
See Appendix A for instructions.
4-8
Accessing Internal Components
Advertisement
Table of Contents
