Using Access Point Mode - Epson PowerLite 735c User Manual

Presenting Through a Wireless Network
34

Using Access Point Mode

In order to use Access Point (infrastructure) mode, first adjust your
projector and network card settings as described in this section.
Configuring the Projector
To configure the projector for Access Point mode, make sure you've
switched it to EasyMP and inserted the network card (see page 28).
Then follow these steps:
1. On the EasyMP Network Screen, the
highlighted as shown below.
2. To select , press the
Config
You see the following screen:
Access point mode
button is already
Config
button on the remote control.
Enter
Config button