Connecting A Desktop System; Using The Macintosh Desktop Adapter - Epson PowerLite 735c User Manual

Connecting a Desktop System

1. Disconnect the monitor cable from the video port on the back of
the computer.
2. Locate the VGA cable that came with the projector. Connect one
end to the projector's
the other end to your computer's video port (where the monitor
was connected).
3. Tighten the screws on the connectors.
If you don't need to make any other connections, you can plug in
your projector and turn it on. See Chapter 1 for instructions.

Using the Macintosh Desktop Adapter

If you have an older desktop Macintosh or PowerBook, the VGA
cable may not fit when you try to connect it. If so, you'll need to use
the Macintosh desktop adapter to connect the VGA cable to your
computer. This is available from EPSON (see page 6).
1. To use the adapter, remove its cover as
shown and set its DIP switches according
to the resolution you want to use, such as
16-inch mode. See your Macintosh
documentation for instructions.
Computer/Component Video
Presenting from Computer or Video Equipment
note
If you have an older
Macintosh, you may need
the Macintosh desktop
port, and
adapter as shown on
page 51 (available from
EPSON; see page 6).
51