Shutting Down The Projector - Epson PowerLite 735c User Manual

note
When the projector has not
received any input signals
for 30 minutes, it
automatically turns off the
projector lamp and enters
"sleep mode." This conserves
electricity, cools the
projector, and extends the
life of the lamp. If you want
to start projecting again,
press the Power button. If
you are done using the
projector, unplug the power
cord. To turn off sleep mode,
see page 81.
caution
To avoid damaging the
projector or lamp, never
unplug the power cord when
the power light is green or
flashing orange.
Displaying and Adjusting the Image
20

Shutting Down the Projector

When you've finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. If you've connected a computer or laptop, shut it down first;
otherwise you may not be able to see your computer's display to
shut it down properly.
2. To turn off the projector, press the red P
projector or remote control.
Power button
You see a confirmation message. (If you don't want to turn it off,
press any other button.)
3. Press the button again. The power light flashes orange for
Power
about a minute and a half as the projector cools down. After the
projector has cooled, the orange light stays on and the exhaust fan
shuts off.
If you want to turn the projector on again, wait until the orange
light stops flashing. Then press the
4. Turn off and disconnect any equipment plugged into the
projector.
5. If you extended the feet, press the side buttons to retract them.
6. Replace the lens cap and unplug the power cord.
7. Store the projector in a protective case.
button on the
Power
button.
Power