Epson PowerLite 735c User Manual page 46

note
For specific details about
your network, please consult
your network administrator.
note
If you don't know your
gateway or access point
address, see page 41.
Presenting Through a Wireless Network
40
10. If your access point uses DHCP, select
. Otherwise select
automatically
and enter the required information:
: Type in the IP address you want to assign to the
IP address
computer. It must be formatted like other addresses on the
network; usually the first three numbers (XXX.XXX.XXX)
match the access point's IP address.
Subnet mask
on how your network is set up.
Default gateway
the access point when it was set up.
11. When done making these settings, click
12. Click the
Wireless Networks
(If you don't see this tab, you may need to enable your wireless
card or network device by clicking
settings; then follow any instructions on the screen to enable the
device.)
Once you click the
13. Verify that you've enabled your computer's connection to the
access point. It should be listed as shown above, with the small
icon next to it, indicating a connection.
Obtain IP address
Use the following IP address
: For example: 255.255.255.000, but depends
: Enter the IP address that was assigned to
OK
tab.
Configure
tab, you see this screen:
Wireless Networks
.
to access the device