Renishaw TONiC FS T3 1 Series Functional Safety Installation Manual And Safety Manual page 6

47 CFR Section 15.27
This unit was tested with shielded cables on the peripheral devices. Shielded cables must be
used with the unit to ensure compliance.
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identifier: TONiC
Responsible Party - U.S. Contact Information
Renishaw Inc.
1001 Wesemann Drive
West Dundee
Illinois
IL 60118
United States
Telephone number: +1 847 286 9953
Email: usa@renishaw.com
ICES-001 — Industrial, Scientific and Medical (ISM) Equipment (Canada)
This ISM device complies with CAN ICES-001.
Cet appareil ISM est conforme à la norme ICES-001 du Canada.
Intended use
The TONiC encoder system is designed to measure position and provide that information to a
drive or controller in applications requiring motion control. It must be installed, operated, and
maintained as specified in Renishaw documentation and in accordance with the Standard Terms
and Conditions of the Warranty and all other relevant legal requirements.
6 TONiC™ FS RELM20/ RSLM20 Functional Safety installation guide and safety manual
Product compliance
This document is an installation guide and safety manual, which details the actions required for
the safe integration of the TONiC Functional Safety (FS) encoder system, as designated by the
T3 prefix in the part number, into a functionally safe system; this will be referred to as TONiC FS
system in the below document.
The TONiC FS system as defined in this document is suitable for use in a Category 3 performance
level d (PLd) application in compliance with ISO 13849 and in a safety integrity level 2 (SIL2)
application in compliance with IEC 61508 and IEC 61800-5-2 when installed and operated in
accordance with the instructions defined.
Failure to follow the correct use instructions and heed the limitations may result in SIL2 and/or
PLd not being achieved and will invalidate the Functional Safety certification.
A copy of the TONiC FS certificate is available from our website at
productcompliance.
Further information
Further information relating to the TONiC FS encoder range can be found at
com/safety-encoders
and is also available from your local Renishaw representative.
Packaging
The packaging of our products contains the following materials and can be recycled.
Packaging
Material
Component
Cardboard
Outer box
Polypropylene
Low density polyethylene foam
Inserts
Cardboard
High density polyethylene bag
Bags
Metalised polyethylene
www.renishaw.com/
www.renishaw.
Recycling
ISO 11469
Guidance
Not applicable Recyclable
PP Recyclable
LDPE Recyclable
Not applicable Recyclable
HDPE Recyclable
PE Recyclable
Original instructions