Removing The Front Bezel And Top Cover; Figure 23 Removing The Front Bezel - Nortel Contivity 5000 Installing

64 Chapter 4 Installing option cards and field replaceable units

Removing the front bezel and top cover

To replace a hard disk drive, you must remove the front bezel from the Contivity
5000. To install option cards or DIMMs, or to replace a fan tray, you must remove
the front bezel and the top cover from the Contivity 5000.
To remove the front bezel:
1
2

Figure 23 Removing the front bezel

315990-D Rev 00
Shut down the Contivity 5000 using the Web GUI or the command line
interface and then unplug it as described in
or replace hardware" on page
You do not need to unplug the gateway to replace a hard disk drive.
Danger: Make sure to turn off the Contivity 5000 and unplug it before
you attempt to install an option card, DIMM, or fan tray.
Using a Phillips screwdriver, turn each of the 2 screws on the front bezel a
quarter turn counterclockwise
"Shutting down the system to add
63.
(Figure 23).
CS260015C