Removing the front bezel and top cover
To install option cards or DIMMs, you must remove the front bezel and the top
cover from the gateway. To remove the front bezel:
1
Shut down the Contivity 1740 using the Web GUI or the command line
interface and then unplug it as described in
or replace hardware" on page
2
Using a Phillips screwdriver, turn each of the 2 screws on the front bezel a
quarter turn counterclockwise
Figure 20 Removing the front bezel
3
Grip the two handles and firmly pull the bezel toward you to unsnap it from
the chassis.
The first few times that you remove the front bezel, it may be somewhat
difficult to remove because the ball studs and socket clips are new.
Danger: Make sure to turn off the Contivity 1740 and unplug it before
you attempt to install an option card or DIMM.
Caution: Do not use the piece with the Nortel Networks logo and the
LEDs as a handle.
Chapter 4 Installing option cards and DIMMs 57
"Shutting down the system to add
56.
(Figure
20).
Installing the Contivity 1740
CS260015D